La section Questions et réponses de la communauté Audiokinetic est un forum où les utilisateurs de Wwise et de Strata peuvent poser des questions et répondre à celles des autres membres de la communauté. Si vous souhaitez obtenir une réponse de la part de l'équipe de soutien technique d'Audiokinetic, veillez à utiliser le formulaire de Tickets de Soutien.

[Unsolved] Auxiliary send volumes attenuation setting

0 votes
I have an User-Defined Auxiliary Send enabled on one of my Actor-Mixers. I created an "Auxiliary Send Volumes (User-Defined)" attenuation curve to control the amount of reverb via Distance, but in game it remains the same all the time (the value is from "General Settings"->"User-Defined Auxiliary Sends tab). Other attenuation curves is OK. What am I doing wrong?
dans General Discussion par Mikhail P. (210 points)
edité par Mikhail P.

2 Réponses

0 votes

Ensure:

  • Your Attenuation is located on the same object as the User-Defined Auxiliary Send.

2013.2.x has a known issue:

WG-24737  Wet disappear when Output Bus Volume volume is at -200 (Voice goes below threshold if dry attenuation is at -200 dB even if wet attenuation is above threshold).

The workaround is change the Output Bus Volume curve to  [0,0] to [max,-90] (instead of 200).  This issue was fixed in 2014.1 beta 1.

par Bernard R. (Audiokinetic) (35.8k points)
My Attenuation is located on the same object as the User-Defined Aux. I tried to enter "-90" value as a minimum attenuation, but in game it still remains constant all the time.
par Mikhail P. (210 points)
0 votes

My Attenuation is located on the same object as the User-Defined Aux. I tried to enter "-90" value as a minimum attenuation, but in game it still remains constant all the time :(

par Mikhail P. (210 points)
Powered by Question2Answer
...